
5
INSTALLATION INSTRUCTIONS
ELECTRICAL CONNECTION
This appliance must be earthed by law. Before connecting
the appliance to the electrical supply, check that the earth
system in your house is working correctly.
Check that unit voltage and power, marked on the rating plate
applied on the appliance, are correct for the supply. It is necessary
that the feeding network is protected by a powerful switch able
to disconnect completely the network with a contacts separation
of at least 3 mm. Be sure that the earth wire green/yellow is
not interrupted by the switch.
WARNING: THIS APPLIANCE MUST BE EARTHED
Connecting the mains cable
Open the mains terminal block cover as shown, unscrew the
cable clamp “A” and unscrew (not fully) the screws in the mains
terminal block which secure the three wires of the mains cable.
Fit the cable and refit the cable clamp “A” (fig. 1 ).
IMPORTANT
The wires in the mains lead are coloured in accordance with the
following code:
GREEN & YELLOW ............................................ EARTH
BLUE.................................................................... NEUTRAL
BROWN............................................................... LIVE
The supply cable must not come into contact with any
component the temperature of which exceeds the ambient
temperature by 50°C.
Easy access to the plug or the switch is ensured once the
appliance is installed.
Ensured that there is sufficient cable allowed for any subsequent
removal of the unit.
In order to avoid hazard, any electrical work performed on this
equipment or its associated wiring should only be done by persons
authorised by the manifacture or similary qualified persons.
Terminal block cover
A
Appliance type Single-phase alimentation 230 V~
All gas
3 x 0,75 mm
2
Ty p e o f c a b l e
All gas + elett. grill
3 x 1,5 mm
2
Rubber H05 RR-F
or
Rubber H05 VV-F
All gas + hotplates
3 x 1,5 mm
2
L
N
A
Fig. 1
Comentários a estes Manuais