Whirlpool KN6G21S(W)/I Instruções de Utilização descarregar pdf (Página 21)

Using the hob

Lighting the burners

For each BURNER knob there is a complete ring

showing the strength of the flame for the relevant

burner.

To light one of the burners on the hob:

1. Bring a flame or gas lighter close to the burner.

2. Press the BURNER knob and turn it in an

anticlockwise direction so that it is pointing to the

maximum flame setting E.

3. Adjust the intensity of the flame to the desired

level by turning the BURNER knob in an

anticlockwise direction. This may be the minimum

setting C, the maximum setting E or any position in

between the two.

If the appliance is fitted with

an electronic lighting device*

(

see figure

), press the ignition

button, marked with the

symbol

, then hold the

BURNER knob down and turn

it in an anticlockwise direction,

towards the maximum flame setting, until the burner

is lit.The burner may be extinguished when the knob

is released. If this occurs, repeat the operation,

holding the knob down for a longer period of time.

! If the flame is accidentally extinguished, switch off

the burner and wait for at least 1 minute before

attempting to relight it.

If the appliance is equipped with a flame failure

safety device*, press and hold the BURNER knob

for approximately 2-3 seconds to keep the flame

alight and to activate the device.

To switch the burner off, turn the knob until it

reaches the stop position

•.

Practical advice on using the burners

For the burners to work in the most efficient way

possible and to save on the amount of gas

consumed, it is recommended that only pans that

have a lid and a flat base are used. They should also

be suited to the size of the burner.

Start-up and use

Burner ø Cookware diameter (cm)

Rapid (R) 24 - 26

Semi-Rapid (S) 16 - 20

Auxilliary (A) 10 - 14

Ultrarapid (UR) 24 - 26

To identify the type of burner, please refer to the

diagrams contained in the “Burner and nozzle

specifications”.

! On the models supplied with a reducer shelf,

remember that this should be used only for the

auxiliary burner when you use casserole dishes with

a diameter under 12 cm.

Using the oven

! The first time you use your appliance, heat the

empty oven with its door closed at its maximum

temperature for at least half an hour. Ensure that the

room is well ventilated before switching the oven off

and opening the oven door. The appliance may emit

a slightly unpleasant odour caused by protective

substances used during the manufacturing process

burning away.

! Never put objects directly on the bottom of the

oven; this will avoid the enamel coating being

damaged.

Lighting the oven

To light the oven burner, bring

a flame or gas lighter close to

opening F (

see figure

) and

press the OVEN control knob

while turning it in an

anticlockwise direction until it

reaches the MAX position.

If the appliance is fitted with an electronic lighting

device* (see figure), simply press the OVEN control

knob and turn it in an anticlockwise direction,

towards the MAX position, until the burner is lit. If,

after 15 seconds, the burner is still not alight,

release the knob, open the oven door and wait for at

least 1 minute before trying to light it again. If there

is no electricity the burner may be lit using a flame

or a lighter, as described above.

Only available in certain models.

WARNING! The glass lid can break in if

it is heated up. Turn off all the burners

and the electric plates before closing

the lid. *Applies to the models with

glass cover only.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Comentários a estes Manuais

Sem comentários

Whirlpool KN6G21S(W)/I Instruções de Utilização Página 21

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Whirlpool KN6G21S(W)/I