Whirlpool ESDF 6040 FS Instruções de Utilização descarregar pdf (Página 8)

Connection to the terminal block

For the electrical connection, use an H05RR-F cable as specied in the table below.

Wires

220-240 V ~ +

220-240 V 3 ~ +

380-415 V 3N ~ +

380-415 V 2N ~ +

Number x size

3 x 4 mm²

4 x 1,5 mm²

5 x 1,5 mm²

4 x 1,5 mm²

Important:

- Based on the wiring diagram (see gure) either keep or remove the metal jumpers between the screws on the terminal block L1-L2 and N1-N2.

- If the cable is provided, see the connection instructions attached to the cable.

- Make sure all six screws on the terminal block are tightened after connecting the cables.

Example of jumper present (left) or removed (right). See the wiring diagram for details (the jumpers can be between L1-L2 and between N1-N2).

Connect the yellow/green earth wire to the terminal with the symbol .

This wire must be longer than the other wires.

1. Remove the terminal block cover (A), undoing the screw and inserting the cover in the terminal block hinge (B).

2. Insert the power cable in the cable clamp and connect the wires to the terminal block as indicated in the connection diagram located near it.

3. Secure the power cable with the cable clamp.

4. Close the cover (C) and screw it on the terminal block with the previously removed screw.

Each time the power is connected, the hob performs an automatic check for a few seconds. If the hob already has a power cable, follow the instructions

attached to the cable. Connect the appliance to the power supply by means of a multipole switch with minimum contact gap of 3mm.

INSTRUCTIONS FOR USE

Control Panel Description

Control panel

Cooking zone and corresponding display

Timer

on/oﬀ

Control panel lock

Power management/

Ecobooster funcon

Switching the hob ON/OFF

To switch the hob on, press the button for approx. 2 seconds until the cooking zone displays light up. To switch off, press the same button until the displays

switch off. All the cooking zones are deactivated If the hob has been in use, the residual heat indicator “H” remains lit until the cooking zones have cooled down.

If within 10 seconds of switching on, no function is selected, the hob switches off automatically.

Switching on and adjusting cooking zones