Whirlpool ACM 152XE0 Guia do Utilizador descarregar pdf (Página 9)

Installation tips

l Handle the air conditioner with care. Watch

l Do not install the air conditioner in an area

out for the sharp metal fins on the front

where the front panel will be exposed to

and rear coils.

heat sources that will raise the panel

l Be sure your air conditioner does not fall

surface temperature above 120°F (50°C).

out of the opening during installation.

Window installation

1. Remove the ground wire and screw from

the front of the unit base. Save grounding

screw for reattachment in Step 23.

2. Attach 3/g” (10 mm) seal strip (A) to

bottom of both side mounting brackets

(sides with screw holes). Cut strips to

length and save extra for use later.

3. Attach side mounting brackets (B) to

cabinet. Place side mounting brackets on

cabinet so bent edge is toward front of

cabinet. Attach each with 2 hex-head

metal screws (C).

4. Slide unit out of cabinet. Grasp handle

and slide unit straight out of cabinet. Place

unit on cardboard to protect your floor.

5. Place empty cabinet in window. Lower

window sash to hold cabinet in place.

Make sure the cabinet is centered in the

window opening.

6. Measure width of window channel and

subtract thickness of filler board. Cut

foam blocks 1/4” (6 mm) wider than this

measurement. The blocks will be used

later in Step 15.

7. Determine proper size for filler board

(D). Measure the distance from the right

edge of the cabinet to the inside of the

right window channel. Then add KY”

(3 mm) to that measurement. Repeat for

left side.

I

H

I

continued on next page

9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Comentários a estes Manuais

Sem comentários