Whirlpool AKR 313/IX Instruções de Utilização Página 21
- Página / 48
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
ASSEMBLY
After having cleaned the perimeter surface, apply the supplied gasket to the hob as shown in the gure.
Position the hob in the worktop opening made respecting the dimensions indicated in the Instruction.
NOTE: the power supply cable must be long enough to permit its upward extraction.
To secure the hob, use the brackets (A) provided with it. Fit the brackets into the relevant bores shown by the arrow and fasten them by means of their screws in accordance
with the thickness of the worktop (see the following gures).
Top 20 mm
Top 30-50 mm
ADJUSTMENT TO DIFFERENT TYPES OF GAS
This operation must be performed by a qualied technician.
If the appliance is intended to operate with a different gas from the gas type stated on the rating plate and information label on the top of the hob, change the injectors.
Remove the information label and keep it with the instructions booklet.
Use pressure regulators suitable for the gas pressure indicated in the Instruction.
• The gas nozzles must be changed by After Sales Service or a qualied technician.
• Nozzles not supplied with the appliance must be ordered from After Sales Service.
• Adjust the minimum setting of the taps.
NOTE: when liquid petroleum gas is used (G30/G31), the minimum gas setting screw must be tightened as far as it will go.
IMPORTANT: should you experience difculty in turning the burners knobs, please contact the After Sales Service for the replacement of the burner tap
if found to be faulty.
REPLACING THE INJECTORS (see the injector table in the Instruction)
• Remove grids (A).
• Extract burners (B).
• Using a socket spanner of the appropriate size unscrew the injector (C), unscrew the injector to
be replaced.
• Replace it with the injector suitable for the new type of gas.
• Re-assemble the injector in (D).
• If you have a multiple crown burner use side spanner to replace the injector (E).
Before installing the hob, remember to afx the gas calibration plate supplied with the injectors in
such a way that it covers the existing information relating to gas calibration.
ADJUSTING MINIMUM GAS SETTING OF TAPS
To ensure that the minimum setting is correctly adjusted, remove the knob and proceed as follows:
• tighten screw to reduce the ame height (-);
• loosen screw to increase the ame height (+)
The adjustment must be performed with the tap in minimum gas setting position (small ame) .
• The primary air of the burners does not need to be adjusted.
• At this stage, light up the burners and turn the knobs from max position to minimum position to check ame stability.
Upon completion of adjustment, reseal using sealing wax or an equivalent material.
REFERENCE TO LOCAL REGULATIONS
Provision for ventilation
The room in which the appliance is installed must have an air supply to current B.S. 5440 - Part 2 standards.
All rooms require a permanent vent in addition to the openable window.
If there are other fuel burning appliances in the same room B.S. 5440 - Part 2 should be consulted to determine the air vent requirements.
If the appliance is installed in a cellar or basement, it is advisable to provide an air vent of 65 cm, irrespective of the room volume.
Gas Safety Regulations
The law requires that all gas appliances are installed by competent persons in accordance with the current gas safety regulations. Failure to install appliances correctly
may lead to prosecution. It is in your own interest, and that of safety, to ensure that the law is complied with. The hob should be installed in accordance with the
WARNING
- ОСТОРОЖНО 1
- ОПИСАНИЕ ПРИБОРА 5
- ИСПОЛЬЗОВАНИЕ ВАРОЧНОЙ ПАНЕЛИ 5
- НЕБЕЗПЕКА 7
- ЗБЕРІГАЙТЕ ЦЮ ІНСТРУКЦІЮ 8
- ПІДКЛЮЧЕННЯ ГАЗУ 8
- ПІДКЛЮЧЕННЯ ДО ЕЛЕКТРОМЕРЕЖІ 8
- Поверхня 20 мм 9
- Поверхня 30-50 мм 9
- ЗАХИСТ ДОВКІЛЛЯ 10
- ОПИС ВИРОБУ 11
- 4000 108 09546 13
- БҰЛ НҰСҚАУЛЫҚТАРДЫ САҚТАҢЫЗ 14
- ГАЗДЫ ҚОСУ 14
- ЭЛЕКТР СЫМДАРЫН ЖАЛҒАУ 14
- ҚҰРАСТЫРУ 15
- СƏЙКЕСТІЛІК ДЕКЛАРАЦИЯСЫ 16
- ҚОРШАҒАН ОРТАНЫ ҚОРҒАУ 17
- ӨНІМ СИПАТТАМАСЫ 17
- ПЛИТАНЫ ПАЙДАЛАНУ ƏДІСІ 17
- BUILT-IN GAS HOB INSTRUCTIONS 19
- SAVE THESE INSTRUCTIONS 20
- GAS CONNECTION 20
- ELECTRICAL CONNECTION 20
- ASSEMBLY 21
- WARNING 22
- Burner Pot Ø 23
- PELIGRO 25
- GUARDE ESTAS INSTRUCCIONES 26
- CONEXIÓN DEL GAS 26
- CONEXIÓN ELÉCTRICA 27
- DECLARACIÓN DE CONFORMIDAD 28
- ADVERTENCIA 28
- Ø de recipiente 29
- 1 PB 2C - 2 SR - 1 AUX 30
- GUARDE ESTAS INSTRUÇÕES 32
- LIGAÇÃO DO GÁS 32
- LIGAÇÃO ELÉCTRICA 33
- MONTAGEM 33
- REFERÊNCIA A NORMAS LOCAIS 34
- SERVIÇO PÓS-VENDA 34
- DESCRIÇÃO DO PRODUTO 35
- COMO USAR A PLACA 35
- PERICOLO 37
- AVVERTENZA 37
- COLLEGAMENTO GAS 38
- MONTAGGIO 39
- DICHIARAZIONE DI CONFORMITÀ 40
- DESCRIZIONE DEL PRODOTTO 41
- UTILIZZO DEL PIANO DI COTTURA 41
- ΠΡΟΕΙΔΟΠΟΙΗΣΗ 43
- ΦΥΛΑΞΤΕ ΑΥΤΕΣ ΤΙΣ ΟΔΗΓΙΕΣ 44
- ΣΎΝΔΕΣΗ ΑΕΡΊΟΥ 44
- ΗΛΕΚΤΡΙΚΗ ΣΥΝΔΕΣΗ 45
- ΣΥΝΑΡΜΟΛΟΓΗΣΗ 45
- ΔΗΛΩΣΗ ΣΥΜΜΟΡΦΩΣΗΣ 46
- ΠΕΡΙΓΡΑΦΗ ΤΗΣ ΣΥΣΚΕΥΗΣ 47
- ΤΡΟΠΟΣ ΧΡΗΣΗΣ ΤΗΣ ΕΣΤΙΑΣ 47
- +3H2II ΑΙΡΟΓΗΤΑΚΚΕΠΜ ΣΑΚΑΝΙΠ 48
Manuais e produtos relacionados com Fogões Whirlpool AKR 313/IX
Fogões Whirlpool PSC 04 T Instruções de Utilização
(32 páginas)
(32 páginas)
Fogões Whirlpool AKS 338/IX Instruções de Utilização
(24 páginas)
(24 páginas)
Air King 4TM65A/9530A manuali
Manuali dei proprietari e guide per l'utente per Fax Air King 4TM65A/9530A.
We fornisce 1 manuali pdf Air King 4TM65A/9530A per scaricare gratuitamente in base al tipo di documento: Manuale Utente
Comentários a estes Manuais