Whirlpool MINIK. MK100T PV Instruções de Utilização descarregar pdf (Página 10)

INSTALLATION

Before installation, make sure that the tubes on

the rear of the refrigerator have not been bent in

transit. If the tubes touch the refrigerator or the

wall, the refrigerator will be irritatingly noisy

during operation.

If necessary, bend them carefully to restore the

correct clearance.The Mini-kitchen must be

installed in a fixed and plumb upright position.

Any unevenness of the floor can be

accommodated by adjusting the feet.

Warm air must be free to escape unobstructed at

the rear of the refrigerator so as not to affect

operation (and not to cause increased electrical

power consumption). Accordingly, the

ventilation slots near the hotplates must not be

covered.

The machine is approved only for installation

against a wall. No free-standing installation with

back far from wall is allowed, neither built-in

installation in a closed cabinet.

Only items of furniture may be placed adjacently

on either side.

Note: To align the height of the doors, adjust the

front feet.

To install an extractor hood...

Observe the minimum distance from the

hotplates! Minimum distance between electric

hotplates and lower edge of extractor hood:

650mm. For reasons of safety this distance must

absolutely be maintained!

1 2 ... 5 6 7 8 9 10 11 12 13 14

Sem comentários

Whirlpool MINIK. MK100T PV Instruções de Utilização Página 10