Whirlpool TI 7524 (NR) Instruções de Utilização descarregar pdf (Página 15)

GBGB

 The glue applied on the gaskets leaves traces of

grease on the glass. Before using the appliance, we

recommend you remove these with a special non-

abrasive cleaning product. During the first few hours

of use there may be a smell of rubber which will

disappear very quickly.

 A few seconds after the hob is connected to the

electricity supply, a buzzer will sound. The hob may

now be switched on.

Switching on the hob

To switch the hob on, press and hold the button

for approximately one second.

Switching on the cooking zones

Each cooking zone is controlled by a device

consisting of two buttons (- and +).

 Press the

button to activate the hotplate, then

set the power to the required level using the

and buttons.

 To set the power to maximum, hold down the

button briefly.

Booster function*

The booster function for the 4 cooking zones may be

used to shorten heating-up times. It can be

activated by pressing the

button. The letter "P"

appears on the power indicator display. This

function boosts the power of the front left and rear

right cooking zones to 3000 W and the rear left and

front right cooking zones to 1200 W.

It stops automatically after 4 minutes. The booster

function may be activated in all 4 cooking zones at

the same time. In this case, the maximum power of

the booster function will be as follows:

for the rear right and front left zones, 2400 W;

for the rear left and front right zones, 1200 W.

While the booster for the front right and rear left

cooking zones is active, the power of other two

zones is limited to a maximum of 600 W (e.g. if the

rear left hotplate booster is activated, the power of

the front left hotplate decreases).

Switching off the cooking zones

 Press the button: the power of the cooking

zone will progressively decrease until it is

switched off.

 Alternatively, the

and buttons may be

pressed simultaneously. This immediately returns

the power setting to 0 and the cooking zone

switches off.

Programming the cooking time

 All the cooking zones may be programmed for a

length of time between 1 and 99 minutes.

1. Select the cooking zone using the corresponding

selector button.

2. Adjust the temperature.

3. Press the

programming button.

3. Set the cooking time using the - and + buttons.

4. Confirm by pressing the

button.

The timer begins counting down immediately. A

buzzer sounds for approximately 1 minute and the

cooking zone switches off when the set programme

has finished.

Repeat the above procedure for each hotplate you

wish to programme.

Control panel lock

When the hob is switched on, it is possible to lock

the oven controls to avoid accidental changes being

made to the settings (by children, during cleaning,

etc.). Press the

button to lock the control panel:

the indicator light above the button will switch on.

To use any of the controls (e.g. to stop cooking),

you must switch off this function. Press the

button for a few moments, the indicator light will

switch off and the lock function will be removed.

Switching off the hob

Press the button to switch the appliance off.

If the control panel lock has been activated, the

controls will continue to be locked even after the hob

is switched on again. In order to switch the hob on

again, you must first remove the lock function.

Start-up and use

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Comentários a estes Manuais

Sem comentários

Whirlpool TI 7524 (NR) Instruções de Utilização Página 15

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Whirlpool TI 7524 (NR)