Whirlpool CHI 6640F IN Instruções de Utilização Página 7

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 16
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 6
EN13
After unpacking the product, check for any damage during transport. In case of problems, contact the dealer or the After-Sales Service.
PREPARING THE CABINET FOR FITTING
Electrical connections
Important!
Electrical connection must be made before connecting the oven to the
electricity supply.
The appliance must be earthed.
For electrical connection, refer exclusively to the instructions given in the
following paragraph, ignoring the connections indicated on the underside of
the hob.
Connecting the cable (included) to the terminal block
1. Remove the terminal block screws and the jumpers.
2. Connect the wires to the terminal block as shown in the wiring diagram below.
3. Secure the cable with the cable clamp next to the protective black sheath.
4. Remove the terminal block cover (A), undoing the screw and inserting the
cover in the terminal block hinge (B). Close the cover (C) and screw it on the
terminal block.
RECOMMENDED POT BOTTOM WIDTHS
Ø
28 cm
XL
Ø
17 cm 28 cm
Ø
21 cm
L
Ø
15 cm 21 cm
Ø
18 cm
M
Ø
14,5 cm
16 cm
S
Ø
12 cm 18 cm
Ø
10 cm 14,5 cm
16 cm
INSTALLATION
WARNING
- The lower part of the product must not be accessible after installation.
- In case of installation of an undertop oven, do not interpose the separator panel.
In order to ensure the correct operation of the product, do not obstruct the minimum required clearance between the hob and the top of the unit (min. 5 mm).
If an oven is installed beneath the hob, make sure the oven is equipped with a cooling system.
To remove the hob from the worktop use a screw driver (not supplied) unlocking the springs from the bottom side of the appliance.
ELECTRICAL CONNECTION
WARNING
- Disconnect the appliance from the power supply.
- Installation must be carried out by qualified personnel who know the current safety and
installation regulations.
- The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the
regulations provided in this chapter.
- Make sure the voltage specified on the dataplate located on the bottom of the appliance is the same as that of the home.
Legend:
- R = brown
- S = brown
- E = yellow/green
- N = blue
- N = blue
Vista de página 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comentários a estes Manuais

Sem comentários