Whirlpool C 647 G (W)R Instruções de Utilização descarregar pdf (Página 15)

N.B.: in the case of liquid gas, the regulation screw must be

screwed in to the bottom.

• check that the flame does not turn off when you turn the tap

quickly from high to low.

d) Regulating the primary air of the burners:

The primary air of the burners requires no regulation.

Adapting the gas oven to different types of gas

a) Replacing the oven burner nozzle:

• remove the warming drawer;

• in the case of models without warming drawer, remove the

panel “P” as indicated in Fig. A. Open the door, release the

two top inserts by pressing them downwards, and then the

two bottom inserts by pressing them upwards.

• remove the sliding protection “A”;

• remove the two screws to dismount the protection “B”; (see

Fig. B);

• remove the screw and then the oven burner “V”(see Fig. C).

Remove the oven door to facilitate this operation.

• unscrew the oven burner nozzle using the special socket

spanner for the nozzles (see Fig. D), or better still a 7 mm

socket spanner, and replace it with a nozzle suited to the

new type of gas (see table 1).

Fig. A Fig. B

Fig. C Fig. D

b) Minimum regulation of the gas oven burner with thermostat

(see fig.):

• light the burner as described in the paragraph “the oven knob”

of the instruction booklet.

• turn the knob to Max for about 10 minutes and then turn the

knob to the Min setting;

• remove the knob;

• regulate the screw positioned outside the thermostat pin

until the flame is small but steady.

N.B.: in the case of liquid gas, the regulation screw must

be screwed in to the bottom.

• check that the burner does not turn off when you turn the

knob from Max to Min and and when you open and close

the oven door quickly.

Adapting the gas grill to different types of gas

Replacing the nozzle of the grill burner:

• remove the screw and then slide out the grill burner “V”

(see Fig. E);

• unscrew the grill burner nozzle using the special socket

spanner for the nozzles (see Fig. F) or better still a 7 mm

socket spanner; replace the nozzle with a nozzle for the new

type of gas (see table 1).

Fig. E Fig. F

Important: when mounting the grill burner check that there is a

space of at least 4 mm between the security thermocouple (if

installed) and the burner.

Important

On completion of the operation, replace the old rating sticker

with one indicating the new type of gas used. This sticker is

available from our Service Centres.

Note

Should the pressure of the gas used be different (or vary) from

the recommended pressure, it is necessary to fit a suitable

pressure regulator onto the inlet pipe in compliance with current

National Regulations relative to “regulators for channelled gas”.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 45 46

Comentários a estes Manuais

Sem comentários

Whirlpool C 647 G (W)R Instruções de Utilização Página 15

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Whirlpool C 647 G (W)R