63
ELECTRICAL CONNECTION
Electrical connection must be made before connecting the
appliance to the electricity supply. The appliance must be installed
by a qualified technician who is fully aware of current safety and
installation regulations. Specifically, installation must be carried out
in compliance with the regulations of the local electricity supply
company. Make sure that the voltage shown on the rating plate is
the same as the power supply voltage in your home. Regulations
require that the appliance is earthed: use conductors (including the
earth conductor) of the appropriate size only. The manufacturer
declines all liability for injury to persons or animals and for damage
to property resulting from failure to observe the above regulations.
For the electrical connection use a HO5 RR-F type cable as
indicated in the table below:
Power supply voltage.
If the hob comes already supplied with a power supply
cable, see the diagram for connection to the mains
electricity supply.
The appliance must be connected to the electricity supply
by means of an all-pole disconnect switch with minimum
contact gap of 3 mm.
Attention
: the power supply cable must be long enough to allow
the hob to be removed from the worktop and must be
positioned so as to avoid damage or overheating caused by
contact with the base.
Connecting to the terminal board
Note
: the yellow/green earth wire must be connected to the
terminal with the symbol and must be longer than the other
wires.
Open the terminal board as shown on the cover
(A)
Strip approx. 70 mm of sheath from the power supply cable
(B)
.
Strip approx. 10 mm of sheath from the wires. Next insert the
power supply cable into the cable clamp and connect the
wires to the terminal board as indicated in the diagram next to
the terminal board itself.
Secure the power supply cable
(B)
by means of the cable
clamp.
Close the terminal board with the cover
(A)
.
After the electrical connection, fit the hob from the top and
hook it to the support springs, following the diagram.
Each time the hob is connected to the mains it carries out an
automatic check which lasts several seconds.
Conductors Amount x size
230 V ~
~
3 X 2.5 mm
2
230 V 3 + ~
~
4 X 1.5 mm
2
400 V 3N + ~
~
5 X 1.5 mm
2
400 V 2N + ~
~
4 X 1.5 mm
2
31963008GB.fm Page 63 Tuesday, February 28, 2006 1:05 PM
(16 páginas)
(12 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais