Whirlpool C 1010 IS Instruções de Utilização descarregar pdf

-1-

Chart

ON/OFF

BUTTON

PROGRAMME

AND DELAY

SELECTOR

KNOB

(see at right for

options description

and table of

programmes below)

START BUTTON

The indicator lights up during operation, flashes when a fault occurs, and goes off

at the end of the programme.

START BUTTON RESET FUNCTION:

Press this button for at least 2 seconds; the selected programme and options will

be cancelled. Main failure displays (repeated flashing of the START indicator lamp)

can be cancelled by RESETTING. Detailed instructions are given in chapter

“What to do if...”.

1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional

options) and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programmes as a result of

the appliance’s automatic calibration system.

2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed

information on the EN/Standard loading comparison test and other tests, contact the following address:

“[email protected]”.

(**) It is recommended to check the cleanness of the filter and clean it if necessary, to assure the correct functioning of the washing

programme.

Table of programmes

Detergent

Consumption

Programmes

Available

options

Loading instructions Litres kWh

Minutes

Eco Green 50°C

Delay

Usual dirty dishes. Not for full

load, for minimum consumptions

(**)

X 13.0 0.90 126

Pre-Wash cold

Delay Crockery to be washed later. — 5.0 0.02 10

Quickwash 40°C

Delay

Lightly soiled crockery, with no

dried-on food.

* Use of tablets

not recommended.

13.0 0.70 30

Eco

50°C

Delay Normally soiled crockery. X 15.0 1.05 150

Intensive 70°C

Delay

Recommended programme for

heavily soiled crockery, especially

suitable for pots and pans.

X 17.0 1.65 145

Switch on the appliance

- press the ON/OFF button.

OK/Start lamp flashes.

Set the desired start delay (3-6-9h). The

selected start delay lamp (3-6-9h)

flashes.

Press the OK/Start button for

confirmation. After that the OK/Start

lamp switches off and the selected start

delay lamp lights up.

If you wish another time setting, press

OK/Start button again.

Turn the programme knob to your

desired programme position.

The OK/Start lamp flashes.

Press the OK/Start button for

confirmation.

After that the OK/Start lamp lights up.

The dishwasher starts immediately or

after the start delay selected.

For a Reset, press the OK/Start button at

a minimum of 2 seconds.

All settings are cancelled.

Indication:

In the selection mode, all

described settings have to be selected

within 30 seconds, otherwise no settings

will be saved.

5019 696 01532C1010

Options and display description

BEFORE USING THE APPLIANCE FOR THE

FIRST TIME CAREFULLY READ THIS QUICK

REFERENCE GUIDE AND THE INSTALLATION

INSTRUCTIONS! THE GUARANTEE IS NOT

APPLICABLE IF FAULTS ARE CAUSED BY

INCORRECT USE OF THE APPLIANCE.

Programme settings

without start delay

Start delay and

programme settings

Quick reference guide

1 2 3 4 5 6 7 8

Resumo do Conteúdo

Página 1 - 5019 696 01532C1010

GB -1-ChartON/OFFBUTTONPROGRAMMEAND DELAY SELECTORKNOB(see at right for options description and table of programmes below)START BUTTONThe indicator li

Página 2 - First time use

GB -2-First time use578623SEL14109In order to always ensure the best cleaning results, you NEED to set: DETERGENT type and WATER HARDNESS.1- salt rese

Página 3 - Daily use

GB -3-Daily check123Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulatorDaily useThe salt level indicat

Página 4 - How to load the racks

GB -4-How to load the racksHJ(depending on the model)G - Foldable plate holders: They can be folded down to load potsorH- Fixed plate holdersI - Cutle

Página 5 - • Press the START button

GB -5-Rectifying minor faults yourself ...Switch off the appliance Everything o.k. ...Wash cycleSelect programmeQuick, permanent or alternating109678O

Página 6 - What to do if

GB -6-What to do if...If a fault occurs, before restoring normal appliance operation.contacting the After-sales Service, make the following checks to

Página 7

GB -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit- Use tablets for soft water. - Set “Detergent type”

Página 8

GB -8-What to do if...Disconnect the mains plugIf, after carrying out the above checks, the fault persists, switch off the appliance, disconnect the m