GB
-1-
Chart
START
DELAY
option
ON/OFF
BUTTON
PROGRAMME
SELECTOR
KNOB
(see “Table of
programmes”
below)
START BUTTON
The indicator lights up during operation, flashes when a fault occurs, and goes off
at the end of the programme.
START BUTTON RESET FUNCTION:
Press this button for at least 2 seconds; the selected programme and options will
be cancelled. Main failure displays (repeated flashing of the START indicator lamp)
can be cancelled by RESETTING. Detailed instructions are given in chapter
“What to do if...”.
(see at right for options description)
HALF
LOAD
option
1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions
(without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible
with sensor programmes as a result of the appliance’s automatic calibration system.
2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: fo
detailed information on the EN/Standard loading comparison test and other tests, contact the following address:
Table of programmes
Deter-
gent
Consumption
P
Programmes
Available
options
Loading instructions Litres kWh
Minutes
1)
1
Pre-Wash cold
Delay Crockery to be washed later. — 5.0 0.02 14
2
Quickwash 40°C
Delay
Lightly soiled crockery, with no
dried-on food. * Use of
tablets not recommended.
X * 13.0 0.70 30
3
Eco
2)
50°C
Delay
Half load
Normally soiled crockery.
Energy saving programme with
prolonged drying cycle.
X 16.0 1.05 195
4
Daily 60°C
Delay
Half load
Normally or heavily soiled
crockery.
X 16.0 1.35 120
5
Intensive 70°C
Delay
Recommended programme for
heavily soiled crockery,
especially suitable for pots and
pans.
X 17.0 1.65 145
DELAYED START
BUTTON
Press the button
(repeatedly) to delay the
start of the programme by
3, 6 or 9 hours.
Then press the START
button. The dishwasher
will start at the set time.
5019 396 01779ADG 673
SALT INDICATOR
When lit, the salt reservoir needs
to be refilled.
Options and display description
BEFORE USING THE APPLIANCE FOR THE
FIRST TIME CAREFULLY READ THIS QUICK
REFERENCE GUIDE AND THE ASSEMBLY
INSTRUCTIONS! THE GUARANTEE IS NOT
APPLICABLE IF FAULTS ARE CAUSED BY
INCORRECT USE OF THE APPLIANCE.
HALF LOAD
The half load cycle can be
used for the upper or
lower rack.
Select the required
programme then press the
“Half load” button. The
light comes on and goes
off at the end of the
programme.
This function can be used
with the programmes
marked with the relative
description in table.
RINSE AID INDICATOR
When lit, the rinse aid dispenser
needs to be refilled.
Quick reference guide
Comentários a estes Manuais